Tube Fixing, Clamp Fixing & Miscellaneous Ball Transfer Units

Alwayse Engineering Limited
Miller Street
Birmingham B6 4NF
United Kingdom

Telephone: +44 121 380 4700
Fax : +44 121 380 4701

General Tolerance unless stated ±0.3mm

The individual product features are displayed at the foot of the table...

REF No.	Ball Size (mm)	Weight in (Kg's)	Support Load (Kg's)
			TYPE 13 Carbon Steele Bearings, Zinc Plated Pressings		TYPE 15 Stainless Steele Bearings and Pressings
			LOAD UP	LOAD DOWN	LOAD UP	LOAD DOWN
3004	19	0.060	25	10	25	10
1002	25.4	0.120	55	25	55	25
2004	40	0.420	140	60	140	60
3007	19	0.160	25	10	25	10
1001	25.4	0.260	55	25	55	25
1021	32	0.360	125	55	125	55
1004	25.4	0.140	55	25	55	25
1007	25.4	0.140	55	25	55	25
1500	25.4	0.160	100	50	100	50

IMPORTANT - If you are unsure of your requirements, consult us: FREE TECHNICAL ADVICE

To order, specify REF No and TYPE, i.e. 3007-13

3004 - 1002 Tube Fixing		2004 Tube Fixing
	Features: Tube fixing is acheived by pushing the spring washer into a suitable size tube and turning to lock. 3 sizes available . Suitable for use as castor.		Features: Tube fixing is acheived by pushing the bush into the tube. Rotating the unit expands the rubber bush for an interference fit. Excellent as a castor.
3007 - 1001 - 1021 - Clamp Fixing
		Features: The 3007 and 1001 can be fixed to 1mm -10mm thick materials. 1mm - 27mm thick materials for the 1021. The maximum tightening torque is 15Nm for the 3007 and 1001, 20Nm for the 1021. Optional extras: Dirt exit hole.

1004		1007
	Features: Supplied with circlip for loosely fixing to materials up to 6.4mm thick. Dirt exit hole.		Features: Small taper on body allows for interference fixing. Do not strike the ball, use a tube on the flange diameter when fixing. Approx. size of taper is 35.8mm top and 35.4mm bottom. Dirt exit hole.
1500
	Features: High load capacity. Improved rubber knife edge seal wipes debris off outside of ball. Dirt exit hole.

Alwayse Engineering Limited ® | Registered office address as above | Reg. No. 362715 England